Magnet Hooks
Fleetingtag: learning 3D printing magnet hooks
first version
The support was exported with -Z up and the hook with Y up
![](https://konubinix.eu/ipfs/bafkreigoksqnkxevgcgmzy3ia2mkwx2nsoxb4cuxyvgktxrcoycgmuv4xq?filename=a.png)
![](https://konubinix.eu/ipfs/bafybeic4rflecdplno6bnckvr2twjsexef24xkg2uyq42biwaegl5yvdge?filename=a.png)
![](https://konubinix.eu/ipfs/bafybeiai5ixnpuizb3dffw23bqzfychr3j3havsaihxudk2aiefzmojz3i?filename=a.png)
- the holes where two small, I needed to file them,
- the magnet slides, the ledge was not useful,
- the hook is slightly to small,
- 2 holes is a good number, only one magnet was not strong enough to hold a bike helmet,
second attempt
The holes are too big. But the hook is great.
third attempt
![](https://konubinix.eu/ipfs/bafybeihzz6lwbwpt33wtls54clqjotcrwkz4uqbwxwdh2ro7ir575vfbpm?filename=a.png)
It’s great!
Unfortunately, I forgot to save it.
fourth attempt
With only modifications on the support.
It works great !
![](https://konubinix.eu/ipfs/bafybeigiq6bp7agezucqshknxi243usbqmvvf34vneibcqhz536dehduqm?filename=a.png)