Cura Tutorial
Fleeting- External reference: https://all3dp.com/1/cura-tutorial-software-slicer-cura-3d/
2018 Cura Tutorial - Deep Inside the Cura 3D Slicer Software | All3DP
In general, a Wall Thickness of 2 or 3 times the nozzle diameter is sufficient. A higher value will create a sturdier model and decrease the chance of leaks, while a lower value can significantly decrease the print time and filament costs
— https://all3dp.com/1/cura-tutorial-software-slicer-cura-3d/
Setting Z Seam Alignment to Random will start each layer at a random position. This will eliminate the seam completely, but will also lengthen the print time as the print head will require additional time to move to a new position between each layer
— https://all3dp.com/1/cura-tutorial-software-slicer-cura-3d/
if your print is set for two nozzle diameters, Alternate Extra Walls will add an extra nozzle diameter on every odd-numbered layer.
— https://all3dp.com/1/cura-tutorial-software-slicer-cura-3d/
default outer wall speed is 30 mm/s. Setting the outer wall speed a little lower than the default (try reducing in steps of 10 mm/s) can improve the surface finish of the model
— https://all3dp.com/1/cura-tutorial-software-slicer-cura-3d/
The major factors you need to take into account when choosing the infill pattern in the Cura slicer are:
Is the part going to be used for mechanical purposes? Does the model have a large capping surface
— https://all3dp.com/1/cura-tutorial-software-slicer-cura-3d/
large capping surface, then the capping surface will require some support in order to be printed. In such cases, your best infill choice is Concentric. This uses minimal material and is the fastest to print. At the same time, it provides enough support for the top surface
— https://all3dp.com/1/cura-tutorial-software-slicer-cura-3d/
Lines provides the least amount of strength but does not consume a lot of material and prints fas
— https://all3dp.com/1/cura-tutorial-software-slicer-cura-3d/
Grid consumes more material, is slower but provides more strength.
— https://all3dp.com/1/cura-tutorial-software-slicer-cura-3d/
Triangles offer great strength and high lateral loads. Use this infill when you need good wall strength or longer, slender structures
— https://all3dp.com/1/cura-tutorial-software-slicer-cura-3d/
If the model is going to be used for mechanical purposes, the best option is to go for a 3D infill pattern such as Cubic or Tetrahedral
— https://all3dp.com/1/cura-tutorial-software-slicer-cura-3d/
excellent internal support and near isotropic mechanical properties.
— https://all3dp.com/1/cura-tutorial-software-slicer-cura-3d/